(1) The eleven imperial water mill visits testify to the founders' keen interest in the science of hydraulic engineering.

(2) If you see cracks in the walls leaking, some of these can be repaired with hydraulic cement or crack injection.

(3) In the first response stage, the brake pads are placed on the brake disc and the hydraulic pressure increased without initiating braking.

(4) Mitchell reports that further hydraulic analysis will be conducted within the next two weeks by the Water Resources Hydrology department.

(5) After we shot down the catapult, we saw a sheen of hydraulic fluid covering the pressure bulkhead in the back of the aircraft.

(6) The bypass control cylinders automatically bypassed the hydraulic fluid through the actuating cylinder when hydraulic pressure was lost.

(7) Nor did they first pump out all the hydraulic oils and hazardous chemicals, nor cut away potentially dangerous protuberances.

(8) The same is true of the hydraulic and equilibrium notions drawn from other sciences.

(9) Anatomical measurements were done on samples previously used for the analysis of hydraulic parameters.

(10) To raise the capsule through the water, pumps shift about a cup of hydraulic oil from a reservoir in the cylinder to a small external bladder.

(11) Hydraulic fluid

(12) Earth movers, excavators, backhoes, and bulldozers rely on hydraulic fluids to lift, move, scrape, and dig.

(13) Never leave the machine parked with booms or arches suspended off the ground, as they will inject hydraulic oil into the fire if a supporting hose burns through.

(14) When putting away tractors and combines for the winter, take engine and hydraulic oil samples and submit for oil analysis.

(15) This pressurised hydraulic fluid is under the control of an electric solenoid or motor operated valve to achieve the force and position required each time a clutch and/or gear change is needed.

(16) Until now, conventional hydraulic oil would break down sooner, leaving your machine's metal abrasively scraping against metal.

(17) Adequate hydraulic oil flow to the grapple saw has been another problem with a retrofitted attachment.

(18) This pump uses rotating gear assemblies within a pump housing to produce the hydraulic oil flow.

(19) The best time to change hydraulic oil is at the end of the season when contaminants, such as water and dust, are in suspension.

(20) Nevertheless, Henry knew research was expected of him, and he began investigating the chemical reactions involved in the setting of hydraulic cements.