(1) Each antenna features vertical polarization, with an impedance of 50 ohms.

(2) An impedance matching circuit is provided for each signal-carrying wire pair of the first and second wire pair sets.

(3) Will the electric impedance tomography technique be improved further?

(4) Note that impedance and reactance are both given in units of u251cu00f6u251cu00e7u251cu2510ohmsu251cu00f6u251cu00e7u251cu00fb just like resistance.

(5) The transponder alters the impedance of the tuned circuit in accordance with the coded pattern.

(6) If the load impedance is not equal to the transmission line impedance , the wattmeter will indicate the amount of reflected power.

(7) The technique is based on the principle that lean tissue has a higher electrical conductivity and a lower impedance rate than fat.

(8) When impedance is reached, the energy shuts off and a tone alerts OR staff members that fusion is complete.

(9) The instrument must show the true rms value of the voltage across the measuring impedance .

(10) It may be expressed as IX, where X, the reactance, is the imaginary part of the impedance .

(11) A high impedance probe for the spectrum analyzer is essential.

(12) This greatly minimizes crosstalk among signals and helps to balance the effective impedance of each line at high frequencies.

(13) Figure 3 shows the display when the cable is terminated in its characteristic impedance of 50 ohms.

(14) This was because the coupling resistance value had inverse effects on the amount of current arriving and on the impedance of the neurite.

(15) Electrical impedance spectroscopy is a method for studying the structure of organic and inorganic materials.

(16) Electric impedance tomography is a new imaging technique that is potentially capable of monitoring those imbalances.

(17) As the signal propagates down a path, the voltage magnitude is related to the effective impedance up to the point in the signal's flight.

(18) The passive antenna elements are coupled to selectable impedance components.

(19) In contrast, the configurations and sizes of the nozzles of the first and the second head members are identical, and their impedances are also the same.

(20) The constant impedance is maintained despite changes in temperature and voltage by using two external resistors to hold the impedances for all the I / O pins, which can number hundreds in the larger parts.